All parts and tools required for assembly are included.
To protect the acrylic panels assembly surface should be soft, clean and free from debris. A blanket or the packing materials (with staples removed) will protect your lectern from scratching during assembly.
Do not tighten screws completely until completely assembled.

Included with this lectern are:
(12) 1" x 1/4-20 Allen head screws
(4) Clear plastic shelf clips
(1) Shelf Panel
(1) Top Panel with paper ridge (2 brackets pre attached)
(1) Bottom Panel with non-skid feet (2 brackets pre attached)
(1) Front Panel
(2) Side Panels
(1) Allen Wrench

Extra screws may be included.
If any of the parts are missing please contact your sales representative.

Before beginning assembly, loosen all eight (8) screws on the top and base one turn.




Attach the side panels to the base and top. (8) Screws.
Threaded inserts should be facing up on the base and top panels.
Side panes should be oriented as in the lower left picture, with the widest half up.
Do not tighten screws completely.


Lay the top panel onto the body. The angle on the top edge should match the angle of the top panel.
Use the (4) remaining screws to attach the front panel.
Base and top may need to be slightly moved in order for screws to align properly.
Do not tighten screws completely.


Carefully lift the lectern into the standing position.
Tighten screws on the sides and front panels. (12) Screws
Do not over tighten.


Tighten screws on the top and bottom panels. (8) Screws.
Do not over tighten.


Insert (4) plastic shelf clips into four holes on inside of body, one in each hole.
Place shelf panel onto brackets


Lectern can be cleaned using mild detergents and soft cloth. Dry with soft cloth.
Do not use chemical cleaners on the acrylic panels; they may cause hazing or fogging.