LCNTP Series Assembly Instructions

 

Standard and Sound Models:

Peel protective cover off foam tape on the back of front panel at top and bottom. Place one side of panel behind channel. Flex panel and push or snap behind channel on other side. Press in at center of panel to secure tape.

 

Install the back panel by placing one side behind a channel and flexing behind the channel on the opposite side. NOTE: The four holes in the panel align with the four screws on the back.

 

Install shelves over screws and push down to lock in place. NOTE: If you are installing a sound system, do not install bottom shelf.

 

Installing the Audio System:

Install the speaker wire to the back of the speaker. Pass the wire through the unit so that it extends out the back. Secure the speaker with four black push in clips. Install the four large black grommets in the front panel. Install the speaker cover into the grommets.

Install the amplifier mounting bracket. Install the amplifier following the instructions with that unit. NOTE: Discard the black plastic speaker back cover. It is not used in ths application